【水性OM烟道防腐漆】喷砂、除锈，涂刷具体步骤

　　导读：作为管道防腐漆要根据管道所处环境不同而做出不一样的配套选择，水性OM烟道防腐漆是针对烟道特殊环境的特种产品。采用专用环保水性树脂及助剂研磨制成，具有耐酸、耐碱的突出效果。在良好耐溶剂基础上，只要施工过程没有问题，整体效果十分显著。

　　Takeaway: as a pipeline anticorrosive paint according to different environment and make a different choice, anti-corrosive paint is water-based OM the flue for flue special environment of special products. It is made from a special water-based water-based resin and auxiliary agent, and it has a strong acid, alkali resistance and moisture resistance. On the basis of good solvents and mildew, the overall effect is remarkable as long as there is no problem with the construction process.

　　水性OM烟道防腐漆的施工

　　油污除锈成为了大多数防腐漆的第一项工作，水性OM烟道防腐漆也不例外。需要将表面的油污、锈迹、尘土等杂质处理掉。在按照涂刷工艺进行涂装，注意控制烟道内部的稳定性，条件喷枪压力以防震动太大损坏烟道。膜厚度控制在150—180mm左右即可。

　　The oil slick is the first job of most anti-corrosion paint, and the water-based OM flue is no exception. Surface oil, rust, dirt and other impurities should be disposed of. In accordance with the coating process, the internal stability of the flue is controlled and the pressure of the gun is applied to prevent the vibration of the flue. The film thickness is controlled by 150-180mm.

　　水性OM烟道防腐漆的喷砂、除锈

　　喷砂除锈方法：1、喷砂除砂除锈：管道、管道支架等钢结构需要采用喷砂的方式除锈，除锈的时候喷射磨料材质为含水率小于百分之1的石英砂，粒度要求全部通过7号筛。喷砂时，喷射角度和喷枪移动速度喷距都符合要求，喷砂表面为一只的表面粗糙度，既能增加涂层附着力，也可以保证表面平整度。

　　Sandblasting derusting method: 1, sandblasting sand derusting, piping, pipe supports etc steel structure need to adopt the way of sandblasting derusting, cleaning the injection abrasive material for the moisture content of less than one percent of quartz sand, granularity requires all the screen by 7. Sandblasting, spray Angle and spray gun movement distance meet the requirements, sandblasting the surface roughness of the surface for a, can not only increase the coating adhesion, can also ensure that the surface roughness.